Ingredients
- Clear glass ornaments
- Glitter in 4–6 different colors
- Glitter coat adhesive
- White craft paint
- Liner brush
- Ribbon
- Small funnel or rolled kraft paper
Instructions
- Clean and dry the ornament. Make sure the glass ornament is completely clean and dry. Wipe it down with rubbing alcohol to remove residue that could interfere with the adhesive. Let the alcohol evaporate fully before moving on.
- Add adhesive inside the ornament. Squeeze a small amount of glitter coat adhesive into the opening. Gently turn the ornament so the adhesive coats the inside. Tip it upside down and allow any excess adhesive to drain out.
- Let the adhesive set briefly. Leave the ornament upside down for 20–30 seconds so the adhesive can settle. Avoid leaving a large pool inside; too much adhesive may make the glitter clump instead of forming an even, sparkling layer.
- Add several glitter colors. Place a small funnel in the opening, or use a rolled piece of kraft paper as a simple alternative. Add several of your chosen glitter colors. Start with modest amounts—you can add more if the inside still has bare areas.
- Swirl the glitter. Rotate and gently turn the ornament so the glitter moves around the inside surface. Work slowly and watch how the colors combine. If you shake it vigorously, the glitter may bunch in one area rather than spreading in a pleasing pattern.
- Pour out the excess glitter. Tip the ornament over a suitable container or protected surface and pour out loose glitter. Removing the excess helps keep the inside finish neater. Avoid blowing into the ornament, as this can scatter fine glitter into the air.
- Replace the cap and let the ornament dry. Put the ornament cap back in place and leave it to dry. Follow the adhesive product’s directions if they specify a drying time. Keep the ornament still while the coating sets.
- Paint stars and constellations. Once the glitter coating is dry, use a thin liner brush and white craft paint to add stars or constellation patterns to the outside. Small dots work well for stars; connect selected dots with fine lines if you want a constellation effect. Use a light touch and steady your hand by resting your wrist on the work surface.
- Let the paint dry completely. Set the ornament somewhere it won’t roll or be bumped. Wait until the paint is fully dry before handling the painted areas or adding the ribbon.
- Add the ribbon. Thread or tie a ribbon onto the ornament’s cap for hanging. Check that the knot or loop is secure before placing the ornament on a tree or display.
Notes
Work over a protected surface and keep the opening of the ornament clear while you add glitter. If you’re crafting with children, an adult should handle the glass, rubbing alcohol, and any products that require special safety precautions.
